Span-Track Carton Flow Racks

Manufacturer: Span-Track

Span-Track can be added to any new or existing pallet rack. No shelves or intermediate support required!


  • Fits any rack
  • Drop-in design
  • No shelves required

Superior Flexibility: Simply pick up track to easily rearrange/reslot Span-Track to match SKUs.

High Capacity, High Durability: Span-Track takes the abuse of active warehouses and assembly plants. Galvanized steel side channels, 3/4" diameter tempered aluminum full width rollers and full length 3/16" steel axles handle loads up to 50 lbs. per foot.

Unrivaled Flow: Full width rollers provide maximum carton support, 300% more product contact than plastic wheel rails, resulting in better flow, fewer hang-ups and increased throughput.


  • Installs in 1/3 the time of wheel rails
  • Longer useful life
  • No replacement cost

1 Model Available for
Span-Track Carton Flow Racks

*Prices subject to change without notice

Products without prices are not available for purchase through our shopping cart
If you are interested in these products, add them to your quote list by clicking the red button below

Model No. Price Ea. Qty
Span-Track Call for Pricing

1 Option Available for
Span-Track Carton Flow Racks

Span-Track Carton Flow Racks Option Image

Option: Span-Track Low Profile Installation Guide

Low profile Span-Track installs between pallet rack beams.

1. Set Beams
Set front pallet rack beam to desired discharge elevation. Set rear beam at higher elevation for flow.

• Totes: 3/4" to 7/8" pitch per foot
• 1-10 lbs. cartons: 7/8" to 1 1/8" pitch per foot
• 10-30 lbs. cartons: 7/8" to 1" pitch per foot
• 30-60 lbs. cartons: 3/4" to 7/8" pitch per foot

2. Add Labels and End Caps to Hangers
Slip ID labels into clots and snap on end caps.

3. Add Hangers and Track
Place set of hangers on front and rear beams - DO NOT force or hammer hangers onto beams. Not that front of track has a higher hanger bar and rear of track has a low hanger bar. Place track in position on hangers.

Test installed track section for product flow to determine if rear beam needs readjustment for effective pitch.

IMPORTANT: Track section to be test should be loaded and allowed to sit for 24 hours. Then remove cartons at pick fac and check resulting flow. This is the most reliable way to ensure proper flow for your particular products and storage environment.
Model No. Price Ea. Qty
STLPIG Call for Pricing